|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
05-08-2012, 09:50 AM
|
#1 |
|
Senior Member
Join Date: Jul 2011
Location: shelby, nc
Posts: 201
|
radius ball install, wishbone
I'm installing the wishbone to the trans housing. The car had a replacement rubber insert in a large cast housing. I purchased the original which is thinner and has two sides and relies on spring tension and lubrication. I cannot find any good pictures of this and would appreciate any advise.
TD |
|
|
|
05-08-2012, 10:18 AM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Rhode Island
Posts: 1,868
|
Re: radius ball install, wishbone
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
05-08-2012, 01:07 PM
|
#3 |
|
Senior Member
Join Date: Jul 2011
Location: shelby, nc
Posts: 201
|
Re: radius ball install, wishbone
Sponsored Links (Register now to hide all advertisements)
TD |
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:15 PM.