|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-15-2013, 09:38 AM | #1 |
Junior Member
Join Date: Jan 2013
Location: Melbourne FL
Posts: 20
|
Horn connection
While waiting for my hub/drum to arrive, I'm trying to redo my horn and found it to be unconnected inside the shell with only bare wires present. What type termination connector was used originally? Maybe bullet connectors pushed into/between the two spring clips? Or perhaps the wires connect to the clips without any connectors???
Thanks, Larry |
02-15-2013, 09:49 AM | #2 |
Senior Member
Join Date: Sep 2011
Location: Luck WI
Posts: 550
|
Re: Horn connection
Mine has bullet type connectors that push under the spring clips.
__________________
Jon "If you choose to not decide, you still have made a choice!" RUSH Don't tell me what you know..... Tell me what you have done. |
Sponsored Links (Register now to hide all advertisements) |
|
02-15-2013, 09:52 AM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Horn connection
The bullet terminals push in under the spring clips as Jon mentioned. The 2 bullet terminals will point TOWARD each other when installed correctly.
Last edited by Tom Wesenberg; 02-15-2013 at 09:58 AM. |
02-15-2013, 11:11 AM | #4 |
Junior Member
Join Date: Jan 2013
Location: Melbourne FL
Posts: 20
|
Re: Horn connection
Thank you guys.....I woulda had that all wrong.
This list and the people on it are a national treasure! |
02-15-2013, 05:17 PM | #5 |
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Horn connection
Sponsored Links (Register now to hide all advertisements)
__________________
"THE ASSISTANT GURU OF STUFF" |
|
|
Sponsored Links (Register now to hide all advertisements) |
|