|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-29-2014, 12:00 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: VA
Posts: 1,410
|
Removing Hub Dust Cap
My front wheel dust cap has a hex head formed in it, not round like the currently available ones. I have had the other side off before to repack the bearings, but I can't remember if it was threaded or push on. There isn't a "flange" formed either, to pry against. I've tried twisting it off with my smooth jaw channellocks, but it didn't move. I'll try a socket wrench on it, any other suggestions?
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:18 AM.