|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-03-2016, 10:03 AM | #1 |
Junior Member
Join Date: Sep 2012
Posts: 17
|
1938 Tonner Pedal Linkage questions
Can anyone help me with some details or photos to locate where the stop switch and chain(if applicable) are supposed to be located on a 1-ton 1938 truck with cable brakes? I have found info on the pass cars and 1/2 tons but nothing for big trucks.
Also looking for the correct length and location to hook the clutch pedal return spring on the chassis of the same 1-ton truck. I've seen the short spring direct to the close crossmember and I've seen springs that pass through 1 crossmember to hook to the second. Getting really close now!Thanks. |
11-03-2016, 11:46 AM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,767
|
Re: 1938 Tonner Pedal Linkage questions
I don't know if this will help but in the green parts book under the stop light switch
the next item is bolt #24324-S7. It states Bolt (stop light switch to pedal bracket). So maybe the switch is bolted to the bracket. Bob |
Sponsored Links (Register now to hide all advertisements) |
|
11-03-2016, 12:01 PM | #3 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,118
|
Re: 1938 Tonner Pedal Linkage questions
Quote:
|
|
11-03-2016, 02:03 PM | #4 |
Junior Member
Join Date: Sep 2012
Posts: 17
|
Re: 1938 Tonner Pedal Linkage questions
Sponsored Links (Register now to hide all advertisements)
I believe the big trucks may have had them attached to the side of the transmission. Does anyone have a photo of that part? Or a photo of your big truck transmission? |
|
|
Sponsored Links (Register now to hide all advertisements) |
|