|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
08-18-2021, 08:00 AM
|
#1 |
|
Junior Member
Join Date: Feb 2015
Location: Richmond, Indiana
Posts: 7
|
Interior Panel Nails, What Size?
I have seen several posts about proper procedures for installing the wire brads or nails, but haven't been able to find a specification for size of the nail.
What size works best? Also, I'm assuming that stainless steel might be best, to avoid rust stains later on. |
|
|
|
08-18-2021, 08:24 AM
|
#2 |
|
Senior Member
Join Date: Aug 2011
Location: Eagle Bend, MN
Posts: 2,027
|
Re: Interior Panel Nails, What Size?
I don't remember what size I used but if you are using the same wood, it helps to use a bit longer nail than original, just in case you happen to hit an old hole, it will still hold. I used brass nails, that's what was originally in my car.
__________________
"There are some that can destroy an anvil with a teaspoon and shouldn't be allowed to touch anything resembling a tool." |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
08-18-2021, 08:29 AM
|
#3 |
|
Junior Member
Join Date: Feb 2015
Location: Richmond, Indiana
Posts: 7
|
Re: Interior Panel Nails, What Size?
Brass sounds like a good choice; hadn.t thought of that. Thanks!
|
|
|
|
|
08-19-2021, 05:28 AM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 3,488
|
Re: Interior Panel Nails, What Size?
Sponsored Links (Register now to hide all advertisements)
__________________
Bob Bidonde |
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:49 AM.