|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-30-2016, 07:14 PM | #1 |
Senior Member
Join Date: Dec 2014
Posts: 138
|
Installing water pump shaft collar
I have to much water pump shaft in and out play . I have read on the fourm to install shaft collar . The collar comes with a
Plastic washer . I assume the the collar and washer go on the shaft just behind the nose on the water pump . You have the fan , going backwards towards the motor . Front casting of the pump . Then the open space . I think that is where the shaft collar goes . Washer then collar. Am I right . Miff |
07-30-2016, 07:28 PM | #2 |
Senior Member
Join Date: May 2010
Location: Denville NJ
Posts: 964
|
Re: Installing water pump shaft collar
Plastic washer, collar, then the fan blade.
__________________
Model A Ford Club of New Jersey http://www.mafcnj.org Model A Pick Up Owners and Enthusiasts https://www.fordbarn.com/forum/group.php?groupid=5 |
Sponsored Links (Register now to hide all advertisements) |
|
07-30-2016, 07:42 PM | #3 |
BANNED
Join Date: May 2012
Location: inside your RAM
Posts: 3,134
|
Re: Installing water pump shaft collar
be sure to use a hardened metal washer behind the castle nut that holds the fan on. You cannot rely on the nut alone, since it will dig into the soft aluminum.
We use head bolt hardened washers Pioneer S 1018 get from local parts store. Fan should really come with this washer but it doesn't. Without it, the nut digs into the soft aluminum and the fan gets loose and then all is lost
__________________
'31 180A |
07-31-2016, 06:18 AM | #4 |
Senior Member
Join Date: May 2010
Location: Denville NJ
Posts: 964
|
Re: Installing water pump shaft collar
Tbirdbird, would a stainless steel washer be strong enough?
__________________
Model A Ford Club of New Jersey http://www.mafcnj.org Model A Pick Up Owners and Enthusiasts https://www.fordbarn.com/forum/group.php?groupid=5 |
07-31-2016, 09:52 AM | #5 |
BANNED
Join Date: May 2012
Location: inside your RAM
Posts: 3,134
|
Re: Installing water pump shaft collar
sure, if you can get one with a small enough OD, or take a small OD one to start and make the ID bigger.
The Pioneer washers have a small OD and I do not have to fool with a die grinder, etc
__________________
'31 180A |
07-31-2016, 11:44 AM | #6 |
Senior Member
Join Date: Dec 2014
Posts: 138
|
Re: Installing water pump shaft collar
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|