|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-21-2015, 01:19 PM | #1 |
Senior Member
Join Date: Nov 2015
Location: Roseville Ca.
Posts: 141
|
Coil wire Question
I'm finishing up my 12 conversion, I notice that the wire from coil to Dist is very long with metal jacket. Why long & metal jacket ? Also if I'm putting in a balast resistor where dose it go ? do I split the coil wire & put it in ?? Thanks
|
11-21-2015, 02:52 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,756
|
Re: Coil wire Question
If you are asking about the primary wire it should go from the distributor
to the ignition switch. Bob |
Sponsored Links (Register now to hide all advertisements) |
|
11-21-2015, 03:05 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Coil wire Question
I've never seen nor heard of anyone putting a metal wrap around an ignition coil wire, but it was probably done to reduce ignition noise in a radio. I'd go with an original plain solid copper wire which the Model A parts houses sell.
|
11-21-2015, 05:35 PM | #4 |
Senior Member
Join Date: Nov 2015
Location: Roseville Ca.
Posts: 141
|
Re: Coil wire Question
Here is the picture of the wire. From dist to coil .
|
11-21-2015, 06:07 PM | #5 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Coil wire Question
That's the points wire and an easy to connect aftermarket one. It connects to one side of the switch.
|
11-21-2015, 06:22 PM | #6 |
Senior Member
Join Date: May 2010
Location: Eastern CT
Posts: 2,732
|
Re: Coil wire Question
Sponsored Links (Register now to hide all advertisements)
|
11-21-2015, 08:35 PM | #7 |
Senior Member
Join Date: Nov 2015
Location: Roseville Ca.
Posts: 141
|
Re: Coil wire Question
Thank you guys for the Help, Wife printed out a wiring diagram off the internet. Will be firing it up or try in a few days.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|