|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-02-2016, 09:42 PM | #1 |
Junior Member
Join Date: May 2013
Location: Roswell, GA
Posts: 2
|
Rumble seat back cushion attachement
I have a 1931 Model A deluxe Roadster, the Deck Seat Back Cushion assembly
will not stay in place and I need the hooks for the slots in the upper edge of the door. I also need to locate where I might get the hooks for the lower edge of the seat back cushion to fasten the seat back to the deck door panel. Where might I buy these hooks? |
07-02-2016, 10:14 PM | #2 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: Rumble seat back cushion attachement
I do not think anyone makes them...could be wrong. You might have to look at a seat with the hooks or tabs to see how they are assembled and then do so with your seat as I take it it is a reporduction?
Pluck |
Sponsored Links (Register now to hide all advertisements) |
|
07-02-2016, 10:49 PM | #3 |
Senior Member
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,998
|
Re: Rumble seat back cushion attachement
I installed a reproduction lebaron bonney covered unit recently on a coupe and the tabs were included with the seat and springs,
The lower end had a tab if I remember to install the lower end on the bottom (back) side of the rumble lid. They must be available from snyders ( who get the springs made) or lebaron bonney. Larry |
07-03-2016, 08:02 AM | #4 |
Member
Join Date: Dec 2015
Location: Brooklyn Michigan
Posts: 53
|
Re: Rumble seat back cushion attachement
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|