01-20-2021, 04:28 PM | #21 |
Senior Member
Join Date: May 2010
Location: Florida and Penna.
Posts: 4,471
|
Re: MiG help
Loosen the drive wheel, remove contact tip and cut
wire off so 1/4'' sticks out the rear of the tip. Go to your grinding wheel and grind about 1/16" off the front of the tip where the wire is welded to the front of the tip. Now tap the end of the wire at the back of the tip and it will break loose. Run a gas welding tip cleaner in the front of the tip to take the burrs out. Works every time. G.M.
__________________
www.fordcollector.com |
|
|
Sponsored Links (Register now to hide all advertisements) |
|