|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-22-2012, 09:37 PM | #1 |
Member
Join Date: Jan 2012
Location: Camden, maine
Posts: 67
|
Reversing bells 40 rear
I want to reverse bells to move spring in front of axle. What is the procedure for this? Any tips on holding differential in place while doing this? ,converted already to open drive. I know I need to be careful of gasket thickness setup....anything else? Thanks
|
01-22-2012, 10:31 PM | #2 | |
Senior Member
Join Date: May 2010
Location: Mn
Posts: 2,411
|
Re: Reversing bells 40 rear
Sponsored Links (Register now to hide all advertisements)
Quote:
This section is for questions to the Editor. Post your question in the Discussion section, if you want to get some replies........good luck .
__________________
If mama ain't happy, ain't nobody happy. But if daddy ain't happy...RUN |
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|