|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: westbury ny
Posts: 854
|
![]()
finally got my 55 merc on the road after 5 yrs
![]() ![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Abbottstown , Pa.
Posts: 194
|
![]()
Just don't use a impact gun to draw the nut down till it stops ! Use a torque wrench to do the final few turns . That shouldn't be all that bad to do . Just take your time and don't over torque the nut . Also remember to replace the seal while you are there and check the pinion to see if there isn't worn down and leaking .
Jim |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: St. Michael, Minnesota
Posts: 1,713
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|