11-07-2014, 02:29 PM | #1 |
Member
Join Date: Jul 2011
Location: NEPA
Posts: 81
|
Truck engine
Hi everyone, I have an engine that was used to run a emergency water pump for a town. On the casting above the fly wheel is the numbers 11433, and the heads have 81T-LH and 81T- can't read it. It has a 11 inch clutch disk on it, and the fly wheel is drilled for the pressure plate bolt holes only. (no other drilled holes). I have a 32 transmission to go behind it, and my question is, will a pressure plate and 9 inch clutch fit on this fly wheel, or will the fly wheel have to be re drilled and tapped for the 9 inch plate, or do I have to change the fly wheel? Thanks for any help.
|
11-07-2014, 08:18 PM | #2 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
Re: Truck engine
I have a lot 11in. wheels drilled for 9in. clutch and balance wheel and PP I have one at my machinist right now. Walt
|
Sponsored Links (Register now to hide all advertisements) |
|
11-07-2014, 09:33 PM | #3 |
Member
Join Date: Jul 2011
Location: NEPA
Posts: 81
|
Re: Truck engine
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|