|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-19-2019, 01:41 PM | #1 |
Senior Member
Join Date: May 2010
Location: Walker Lake, Nevada
Posts: 304
|
Rumble seat pan...help!
I am having trouble re-installing my rumble lid. I bolted the rumble pan in after I had already installed the lower back panel and cannot figure out if the rear of the curved pan is supposed to go under the lip of the lower back panel. I bolted the curved panel to the sides using the holes that were already there, but the rumble lid scrapes the inner curved panel. It seems like the curved panel needs to be lower or farther back. Also, what are the holes in the curved panel upper lip for?
Should I start over? Is there a recommended sequence for installing the floor pan? Do I need to reposition where it bolts to the triangular support piece? Everything fit ok before I dismantled everything 10 years ago, and these parts are the same! Word to the wise: when dismantling a Model A, take LOTS of pictures during the process. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|