09-22-2012, 10:34 PM
|
#21
|
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Shifting Problem
Quote:
Originally Posted by redmodelt
I think the clutch rebuilding plate we use for assembly and setup is KR Wilson. I set mine to use new disk as a guide and spend more then a little time setting the fingers before locking down the nuts that are made for staking. The clutch face is checked for run out and cleaned up. We do reuse the fiber disks with new clutch springs installed and fingers are cleaned up on a jig if worn from throwout bearing as part of our rebuild.
|
redmodelt,
It's refreshing to hear from someone who REALLY knows the ART of rebuilding clutches!! Too many stories out there. I wonder how many clutches have been screwed up by trying to adjust the fingers IN the car?? Of course, no one would admit it, probably. When I screw up ROYALLY, only the Dog & I know!!! (Wish we had a Dog Smiley) Bill W.
__________________
"THE ASSISTANT GURU OF STUFF"
|
|
|