The Ford Barn

50 merc · 06-11-2011, 08:13 AM

Pulled my new car into the shop and went to move it this morning and it is stuck in gear. The floor shift is sloppy and I can move it but it won't take it out of gear. It is a hurst shifter 3 speed. Any ideas before I get down to look at it would be great

LOWRIDER · 06-11-2011, 10:16 AM

Did you post this over on the HAMB too? They answered the question pretty good over there. Make sure both arms on the shifter line up with the hole in the shifter body, put the trans in neutral (dont run over yourself) then adjust the rods to fit.

50 merc · 06-11-2011, 10:33 AM

Hey thanks lowrider yup that was me thanks again.

50 merc · 06-11-2011, 10:35 AM

Sponsored Links (Register now to hide all advertisements)

Lowrider do you have the setup you show in your avitar. Mine is the same and a linkage slipped on the way home last night I may need some guidence with that too...lol

06-11-2011, 08:13 AM	#1
50 merc Member Join Date: Aug 2010 Location: Ontario Canada Posts: 67	55 3 Speed Over Drive Pulled my new car into the shop and went to move it this morning and it is stuck in gear. The floor shift is sloppy and I can move it but it won't take it out of gear. It is a hurst shifter 3 speed. Any ideas before I get down to look at it would be great

06-11-2011, 10:16 AM	#2
LOWRIDER Senior Member Join Date: May 2010 Location: Kingman Az. 86409 Posts: 419	Re: 55 3 Speed Over Drive Did you post this over on the HAMB too? They answered the question pretty good over there. Make sure both arms on the shifter line up with the hole in the shifter body, put the trans in neutral (dont run over yourself) then adjust the rods to fit.

06-11-2011, 10:33 AM	#3
50 merc Member Join Date: Aug 2010 Location: Ontario Canada Posts: 67	Re: 55 3 Speed Over Drive Hey thanks lowrider yup that was me thanks again.

06-11-2011, 10:35 AM	#4
50 merc Member Join Date: Aug 2010 Location: Ontario Canada Posts: 67	Re: 55 3 Speed Over Drive Sponsored Links (Register now to hide all advertisements) Lowrider do you have the setup you show in your avitar. Mine is the same and a linkage slipped on the way home last night I may need some guidence with that too...lol