The Ford Barn

Sly · 08-31-2015, 12:13 PM

Hi,

does anybody know the exact diameter of the top pin (which goes into the clutch) from the Main Drive gear - new part - (please see attached picture)?

I need to check if my one is to much worn or not.

Thanks in advance...
stefan

Mitch//pa · 08-31-2015, 01:04 PM

the dimensions of
the pilot bearing bore is
0.6693 inch (17.000 mm

Mitch//pa · 08-31-2015, 01:11 PM

here is some addtl info

http://fordbarn.com/forum/showthread...ht=Input+shaft

JohnLaVoy · 09-01-2015, 08:58 AM

They sell new ones that are very well made.

Bob/Kansas City · 09-01-2015, 04:20 PM

Sponsored Links (Register now to hide all advertisements)

The diameter of the end of the shaft where it goes into the pilot bearing should be .668". If there's more than about .001 or .002" of wear it should be replaced.

08-31-2015, 01:04 PM	#2
Mitch//pa BANNED Join Date: May 2010 Location: Bucks County, PA Posts: 11,454	Re: Transmission - Main Drive Gear the dimensions of the pilot bearing bore is 0.6693 inch (17.000 mm

08-31-2015, 01:11 PM	#3
Mitch//pa BANNED Join Date: May 2010 Location: Bucks County, PA Posts: 11,454	Re: Transmission - Main Drive Gear here is some addtl info http://fordbarn.com/forum/showthread...ht=Input+shaft

09-01-2015, 08:58 AM	#4
JohnLaVoy Senior Member Join Date: Jun 2014 Location: Rocklin, CA Posts: 779	Re: Transmission - Main Drive Gear They sell new ones that are very well made.

09-01-2015, 04:20 PM	#5
Bob/Kansas City Senior Member Join Date: May 2010 Location: Lees Summit, MO Posts: 340	Re: Transmission - Main Drive Gear Sponsored Links (Register now to hide all advertisements) The diameter of the end of the shaft where it goes into the pilot bearing should be .668". If there's more than about .001 or .002" of wear it should be replaced.