|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-01-2020, 07:25 PM | #1 |
Senior Member
Join Date: Dec 2012
Location: Payette, ID
Posts: 936
|
1/4 inch hole in shifting tower sloppy
On my 39 transmission, the little 1/4" pin that the slot in the shift lever ball slides over and goes in the hole in the shifting tower is sloppy A letter F drill is perfect. I could cut of a little piece of an F drill and use that . I have been told that you should use softer steel than a drill bit. Can I heat the bit to cherry red and let it cool slowly to anneal it. Is that going to be soft enough
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|