Crankshaft Flange Pins - Follow up

[Vic in E-TN]

Sponsored Links (Register now to hide all advertisements)

Thanks for the input on my question of a few days ago. James Rogers sent me the missing pin. It was a very tight fit and I did not want to risk damaging the new babbit or getting the flange out of round by hammering too hard. I put the pin in the freezer for a few hours and took it out with pliers. It only took a few light whacks with the hammer to put it in.
This time I will put the flywheel on correctly - not backward, if my wife helps out.
Vic