|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-22-2013, 03:34 PM | #1 |
Member
Join Date: Jan 2011
Posts: 69
|
Babbit clearance
I'm overhauling an engine, plastiguaging the babbit mains and rods, etc. Two of the rods measure .001 on one side and .002 on the other I'm thinking about removing a shim, cutting it in half and installing it back on the .001 side making it .002 on both sides. Or should I just leave it alone.
|
02-22-2013, 03:58 PM | #2 |
Senior Member
Join Date: May 2010
Location: Windy City
Posts: 2,919
|
Re: Babbit clearance
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|