|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-28-2018, 02:37 PM | #1 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
hydraulic cylinder sizes
Acquiring the parts to convert '35 to juice brakes using Lincoln style Bendix brakes. Using standard 1 1/16 bore Lockheed master cylinder, what sized front and rear wheel cylinders do these Lincolns run? I have in my possession, a nice pair of stainless sleeved 15/16" dia wheel cylinders I was planning on using out back, unsure of what dia front cylinders to order?
__________________
Unfortunately, two half wits don't make a whole wit! |
07-28-2018, 04:45 PM | #2 |
Senior Member
Join Date: May 2010
Location: Illinois
Posts: 2,184
|
Re: hydraulic cylinder sizes
I used the wheel cylinders that came with the MT car Bendix brakes. I do not know size,so can not help there.
I did find that the 1 1/16 master cylinder required too much pedal pressure. I switched to a 1” Mustang dual M C and it was much better. I have this set up on two cars. John |
Sponsored Links (Register now to hide all advertisements) |
|
07-30-2018, 05:55 PM | #3 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: hydraulic cylinder sizes
Can anyone answer my question please?
__________________
Unfortunately, two half wits don't make a whole wit! |
07-30-2018, 06:15 PM | #4 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,753
|
Re: hydraulic cylinder sizes
According to Rock Auto Lincoln used 1.125" on the front and 1" on the rear.
https://www.rockauto.com/en/catalog/...epair+kit,1956 |
07-30-2018, 06:47 PM | #5 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: hydraulic cylinder sizes
Sponsored Links (Register now to hide all advertisements)
__________________
Unfortunately, two half wits don't make a whole wit! |
|
|
Sponsored Links (Register now to hide all advertisements) |
|