|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-16-2016, 11:20 AM | #1 |
Senior Member
Join Date: May 2010
Location: Suth'N Maine
Posts: 1,996
|
An "adoring" job...
Well not really, this may help some of you if your @ this stage of your "resurrection". First picture is my new Bob Drake door latches, they fit like the originals.
Now here is were the pain begins, the second picture is my old door handle next to the new ones. Notice the middle one (square shaft as they come) and the third one that has been notched. Bob's catalog does have a pictured note "some styles may require the shaft be shortened and/or notched for proper fitting to your latch" they aren't kidding. Creating the notch after cutting the shaft to the original and fitted length can be nicely done with a small square file and a lot of patience. Scott Last edited by 39portlander; 04-15-2018 at 06:05 PM. |
07-16-2016, 10:05 PM | #2 |
Senior Member
Join Date: Oct 2011
Location: elmira,ny
Posts: 1,518
|
Re: An "adoring" job...
evidently B.D. couldn't take the time to manufacture the handles correctly.Then if you mess them up it's on you!
|
Sponsored Links (Register now to hide all advertisements) |
|
07-17-2016, 01:09 AM | #3 |
Senior Member
Join Date: May 2010
Location: S.F.V. Cali.
Posts: 133
|
Re: An "adoring" job...
I have also opened up the stationary square hole in Bob Drake replacement door latches before. Did that just recently on a '36 pickup.
|
07-17-2016, 07:35 AM | #4 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
Re: An "adoring" job...
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|