The Ford Barn

Minn-Tex Lee · 06-09-2012, 01:22 PM

I'm sure everyone except me knew this--
If you remove the light switch bail to perform service inside the light switch body and turn it 180* when you pot it back on -- it won't fit.
Almost but not quite.

Lee

700rpm · 06-09-2012, 03:18 PM

Always good to remind us about stuff. Thanks.

J Franklin · 06-09-2012, 07:52 PM

Sponsored Links (Register now to hide all advertisements)

Did you get it almost bent into shape when this hit you?

06-09-2012, 01:22 PM	#1
Minn-Tex Lee Senior Member Join Date: May 2010 Location: Stewrtvl MN-Fredbrg TX Posts: 192	Light switch bail I'm sure everyone except me knew this-- If you remove the light switch bail to perform service inside the light switch body and turn it 180* when you pot it back on -- it won't fit. Almost but not quite. Lee

06-09-2012, 03:18 PM	#2
700rpm Senior Member Join Date: May 2010 Location: Portland, Oregon Posts: 5,906	Re: Light switch bail Always good to remind us about stuff. Thanks. __________________ Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole.

06-09-2012, 07:52 PM	#3
J Franklin Senior Member Join Date: May 2010 Location: Oregon Posts: 5,964	Re: Light switch bail Sponsored Links (Register now to hide all advertisements) Did you get it almost bent into shape when this hit you?