|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-23-2019, 02:45 PM | #1 |
Senior Member
Join Date: May 2013
Location: Pa.
Posts: 2,174
|
Intake reinstall?
Putting intake back on block. Was very clean when removed on block side & didn’t seem to have any sealing product on it & required minor cleanup & inspection for flat so I’m not planning on sealer on block side of gasket. Intake side definitely had stickum sealer on it. Cleaned scraped intake made sure nice & flat. Question is should I use sealer on intake side of gasket again? I normally wouldn’t on other overhead valve engines I’ve worked on so don’t think so but as it had on to start & my first adventure inside a Flathead thought I’d bounce it off a more knowledgeable source, u guys.
__________________
Nomad Last edited by AnthonyG; 11-23-2019 at 02:52 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|