|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-12-2013, 02:39 PM | #1 |
Junior Member
Join Date: Jul 2013
Location: Hillsdale Mi.
Posts: 1
|
Carb part wanted
City:
Hillsdale
State:
Mi
In need of a Idle adjustment screw for my flathead 8ba
its a holly model 94 2 barrel |
07-12-2013, 03:56 PM | #2 |
BANNED
Join Date: May 2010
Location: stratford,ct
Posts: 5,971
|
Re: Carb part wanted
Idle mix screws or the idle speed screw,mix screws are brass with a spring on them??? ken ct.
|
Sponsored Links (Register now to hide all advertisements) |
|
07-13-2013, 12:46 PM | #3 |
BANNED
Join Date: May 2010
Location: stratford,ct
Posts: 5,971
|
Re: Carb part wanted
How ignorent,dont even get a reply. ken ct.
|
07-13-2013, 01:48 PM | #4 |
Senior Member
Join Date: May 2010
Location: South California
Posts: 6,188
|
Re: Carb part wanted
|
07-13-2013, 02:01 PM | #5 |
BANNED
Join Date: May 2010
Location: stratford,ct
Posts: 5,971
|
Re: Carb part wanted
Its his bad behavior for not even replying to my post on his want ad. ken ct. Sorry if i stepped on YOUR toes.
|
07-13-2013, 02:18 PM | #6 |
Senior Member
Join Date: May 2010
Location: South California
Posts: 6,188
|
Re: Carb part wanted
|
07-13-2013, 02:46 PM | #7 |
BANNED
Join Date: May 2010
Location: Gothenburg Nebraska Just off I-80
Posts: 4,893
|
Re: Carb part wanted
As always it is best to send a PM instead of replying to the add. I wish Ryan would make it like the HAMB where no one bu the OP could reply on the add. Keeping all messages in one place keeps it easier to find. Works much better than having to look all over the site for messages. Just a thought. Rod
__________________
Do the RIGHT thing - Support the H.A.M.B. Alliance!!!! |
07-22-2013, 10:51 PM | #8 |
Senior Member
Join Date: Jun 2010
Posts: 1,022
|
Re: Carb part wanted
Bump
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|