|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-06-2015, 09:23 PM | #1 |
Senior Member
Join Date: May 2010
Location: Williamsburg, Virginia
Posts: 2,658
|
Need A Dimension
I need the width between the front spring shackle mounts at the end of each wishbone, wishbone to wishbone, on a 40 Ford.
For my latest project I am using a 40 front spring in the rear, with 35-36 rear wishbones, connected to a 9" rear. I need that dimension so I can make some kind if fixture to mount it properly. Thanks for your help .... |
08-07-2015, 12:39 PM | #2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 11,059
|
Re: Need A Dimension
Tom, My car sits low so I couldn't reach under it and accurately measure with a tape measurement. But, using a piece of string, I got 42 inches from the centerline of the top wishbone shackle pin to the centerline of the opposite top wishbone shackle pin. I hope someone can measure this distance directly for you. If someone does not, I will jack up my car and remeasure for you again.
Last edited by 19Fordy; 08-07-2015 at 02:19 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
08-07-2015, 02:42 PM | #3 |
Senior Member
Join Date: May 2010
Location: Williamsburg, Virginia
Posts: 2,658
|
Re: Need A Dimension
Thanks for the help!
|
08-07-2015, 09:10 PM | #4 |
Senior Member
Join Date: May 2010
Location: ManchVegas, New Hampshah
Posts: 1,589
|
Re: Need A Dimension
My pickup is in a rented garage right now so I am not able to measure it. I have found this dimension in a couple of catalogs for '35 - '40 perch centers - 38.5". I hope this helps. How is the project going?
__________________
You are never to old to enjoy your childhood. Forty1fordpickup on the HAMB. |
08-08-2015, 02:25 PM | #5 |
Senior Member
Join Date: May 2010
Posts: 1,674
|
Re: Need A Dimension
Tom, A chart in the Posie's catalogue shows the distance I think you're after as 42-3/8" when using a stock length spring. I verified this on a 78-3010 axle and wishbone this morning. Are you using a stock spring or an aftermarket one such as Posie's? If aftermarket, note that there are several different lengths sold if you're not sure exactly what you have.
The 38.5" mentioned above is the distance between the wishbone mounting holes in the axle I believe. Good luck, keep posting pictures as your project proceeds. |
08-08-2015, 02:43 PM | #6 |
Member Emeritus
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
|
Re: Need A Dimension
Sponsored Links (Register now to hide all advertisements)
|
08-08-2015, 03:39 PM | #7 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 11,059
|
Re: Need A Dimension
J: Thanks for posting that.
My 42 inch "string measurement" was close but you did it right. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|