|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-18-2011, 06:29 PM | #1 |
Senior Member
Join Date: May 2010
Location: Innisfil, Ontario Canada
Posts: 1,174
|
1930 Side Mount Brkt. Location
Does anyone have the measurements for the location of the side mount Brackets to the frame on a 1930 Deluxe Coupe?
Or now were to find it? J. Poole The Old Tinbasher |
11-18-2011, 06:47 PM | #2 |
Senior Member
Join Date: Jan 2011
Location: New Zealand
Posts: 670
|
Re: 1930 Side Mount Brkt. Location
At times the position is marked on the frame with small punch marks. Pic below will give the approximate position. There is not much room between the rear engine mount and the brake rod anti-rattler mount. The spare wheel mount base pictured, has been removed from the frame (before I obtained the car) and should be securely riveted in place.
Let me know if you require some actual measurements to go by. The nose cone in the fender will have to be precisely cut in the right position also.
__________________
R.H.D. Author of Model 'A' Ford technical manuals. Supplier of good original RHD parts. |
Sponsored Links (Register now to hide all advertisements) |
|
11-18-2011, 07:05 PM | #3 |
Senior Member
Join Date: May 2010
Location: NE Illinois
Posts: 499
|
Re: 1930 Side Mount Brkt. Location
As RHD said every frame I have seen has them punched where you drill. Take a wire brush to it and I bet you will find them.
|
11-18-2011, 07:07 PM | #4 |
Senior Member
Join Date: May 2010
Location: NW Ohio
Posts: 556
|
Re: 1930 Side Mount Brkt. Location
If you PM your e-mail address, I'll send you the instructions I received from Don Turley that made it real easy for me.
my e-mail ( [email protected] ) Bob Poiry I had to lift the body of my '30 Deluxe Coupe 4" just to get the side aprons off. |
11-19-2011, 08:56 AM | #5 |
Senior Member
Join Date: May 2010
Location: Innisfil, Ontario Canada
Posts: 1,174
|
Re: 1930 Side Mount Brkt. Location
Thanks guys this should help me out. From the pictures and info I should have enough info.
J.Poole |
11-19-2011, 09:59 AM | #6 |
Senior Member
Join Date: May 2010
Location: NW Ohio
Posts: 556
|
Re: 1930 Side Mount Brkt. Location
Sponsored Links (Register now to hide all advertisements)
Tinbasher, you should have no problem with Tom's instructions........ |
12-09-2011, 10:41 AM | #7 |
Senior Member
Join Date: May 2010
Location: Glendale, AZ
Posts: 2,953
|
Re: 1930 Side Mount Brkt. Location
Ken Ehrenhofer has perfected Don's tool even more
Check out page 17 Nov/Dec 2011 Model "A" News |
|
|
Sponsored Links (Register now to hide all advertisements) |
|