|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-16-2018, 11:14 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Liberty, KY
Posts: 901
|
Split valve guide question
Are the split valve guides machined as pairs or are they machined close enough to mismatch the halves? Reason I ask I was digging out some NOS flathead parts in an old warehouse and found a set of 60 hp guides but they had fell out of the box and lay in a pile! Thanks in advance for your help, Dale.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:21 AM.