Clutch Chatter & Flywheel run-out

[BRENT in 10-uh-C]

Originally Posted by Tom Endy

There are two .010 horse shoe shaped brass shims that install in the two ears of the clutch housing where it attaches to the rear of the engine block ...

Hey Tom, I as unaware that the clutch housing attaches to the engine block.

Just kidding, ...I believe you are speaking of the the flywheel housing, and if you re-read my first post, we actually put an indicator on the center of the flywheel and swept it in, and it read less than 0.005" which is within spec.