06-15-2015, 11:51 AM | #1 |
Senior Member
Join Date: May 2010
Location: westbury ny
Posts: 854
|
axle drilling
down to the end of my 5 lug conversion I have ranger 9 inch drums to match the 9 inch 4 lug from the 64 ranchero I made a bushing to center the drum on the axel using one of the original studs my thinking is ford used the 4.50 pattern on both 4 and 5 lug so by centering the drum on the hub I should be good to drill has anyone done this any thoughts thanks I will post pics when done also did a disk conversion using stock 6 cyl spindles along with a duel master and all new suspension parts the springs were the worst
|
06-16-2015, 05:12 PM | #2 |
Senior Member
Join Date: May 2010
Location: westbury ny
Posts: 854
|
Re: axle drilling
ok drilled the axle today bearings tomorrow and then reassembly and see if everything fits its now a 64 ranchero with 94 ranger brake parts everything test fitted ok only modification was rounding the hole for the e brake arm pin and changing the brake strut to a ranger one also have to bleed the brakes
|
Sponsored Links (Register now to hide all advertisements) |
|
06-17-2015, 05:51 PM | #3 |
Senior Member
Join Date: May 2010
Location: westbury ny
Posts: 854
|
Re: axle drilling
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|