|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-16-2010, 06:24 PM | #1 |
Member
Join Date: May 2010
Posts: 52
|
Destributor noise
In a 1951 V/8 dristributor with the engine running there is a tap,tap sound. The distributor has a new cap, new rotor, new points and condenser. There is some end play in the shaft. The engine starts and runs with good power. Any ideas on the cause of this noise and problems it may cause. RR
|
06-16-2010, 08:37 PM | #2 |
Senior Member
|
Re: Destributor noise
Make sure your rotor is pushed all the way down and the cap is seated down. other than that I am clueless, maybe a bent shaft?
|
Sponsored Links (Register now to hide all advertisements) |
|
06-16-2010, 09:20 PM | #3 |
Senior Member
Join Date: May 2010
Location: UXBRIDGE, MA.
Posts: 316
|
Re: Destributor noise
Is the little steel clip on the top of shaft that holds the rotor tight? The rotor goes on to it.
__________________
BOSSY |
06-16-2010, 09:27 PM | #4 |
Member
Join Date: May 2010
Location: New Hope Minnesota 55427
Posts: 37
|
Re: Destributor noise
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|