|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-10-2015, 04:52 PM | #1 |
Member
Join Date: May 2010
Posts: 74
|
Steering sector gasket needed?
Is there supposed to be a gasket between the steering sector housing and the steering housing on a '31 two-tooth steering gear?
|
06-10-2015, 05:24 PM | #2 |
Senior Member
Join Date: May 2010
Location: Pinckney, Mich.
Posts: 174
|
Re: Steering sector gasket needed?
None required
|
Sponsored Links (Register now to hide all advertisements) |
|
06-10-2015, 08:50 PM | #3 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: Steering sector gasket needed?
yes and it is cork
|
06-10-2015, 09:00 PM | #4 |
Senior Member
Join Date: Jan 2015
Location: San Angelo Texas
Posts: 112
|
Re: Steering sector gasket needed?
I have a round cork gasket. There is also a thrust washer but I don't know which way you put it.
|
06-10-2015, 10:15 PM | #5 |
Senior Member
|
Re: Steering sector gasket needed?
Wide, flared, end towards the box.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II |
06-10-2015, 10:16 PM | #6 |
Senior Member
|
Re: Steering sector gasket needed?
Sponsored Links (Register now to hide all advertisements)
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II |
06-11-2015, 12:45 AM | #7 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,159
|
Re: Steering sector gasket needed?
I used a rubber oring in mine when it was last apart, ---I had restored the car 10 years before using the cork,it had shrunk and wasn't doing the job ---now 25+ years on the rubber --- wet inside not outside,
|
06-11-2015, 11:07 AM | #8 |
Senior Member
Join Date: Dec 2011
Location: SW Idaho
Posts: 970
|
Re: Steering sector gasket needed?
Look at the surface of the main (worm) housing where the sector housing meets the main housing. There is a recess where the cork/paper gasket ring lies and seals to the sector housing.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|