03-16-2024, 06:11 PM
|
#1 |
|
Junior Member
Join Date: Nov 2023
Location: Albany mn
Posts: 3
|
1934 engine
What are people doing for rod bearings in a 1934 221 if the rod journals should get ground to 10 under. Also what kind of clearance should I be shooting for between the pistons and cylinders.
|
|
|
|
03-16-2024, 06:20 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Qld, Australia
Posts: 4,218
|
Re: 1934 engine
You need to round up some bearings, they are around, make sure you check the rods as well.
Lawrie |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
03-16-2024, 07:38 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: 1934 engine
Doesn't 1934 have poured bearings?
|
|
|
|
|
03-16-2024, 07:46 PM
|
#4 |
|
Junior Member
Join Date: Nov 2023
Location: Albany mn
Posts: 3
|
Re: 1934 engine
Looking at rod journals, mains I know I'll have to have poured and line bored.
|
|
|
|
|
03-17-2024, 01:02 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,307
|
Re: 1934 engine
There is a bunch up on Ebay now and °.010 ,.020;.030 are pricey.Place a wanted ad here or contact Southside Obsolete in MN.
Last edited by deuce lover; 03-17-2024 at 01:53 AM. |
|
|
|
|
03-17-2024, 06:20 AM
|
#6 |
|
Junior Member
Join Date: Nov 2023
Location: Albany mn
Posts: 3
|
Re: 1934 engine
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:36 PM.