LED shop light follow-up
I took 19Fordy & 40Cpe's suggestions this weekend and did the PVC pipe route. I doubled the cord back on itself "close" to being taught between the lights (IF it is too tight then there is not enough cord slack to plug them into the next light so its a bit of a delicate dance). Then I slide the PVC pipe over the cord and all in all it works pretty good (note 2nd row of lights in the third picture). Thanks of all the previous input and I will post a finished picture tomorrow BUT in the mean time here is a few of the process.
Last edited by rockfla; 01-20-2020 at 08:20 AM.
|