08-18-2018, 03:27 PM | #1 |
Junior Member
Join Date: Feb 2016
Location: florida
Posts: 7
|
1957 ford
does anyone know the thread size on a power steering drag link end where the control valve screws on. tony
|
08-18-2018, 08:39 PM | #2 |
BANNED
Join Date: Jul 2010
Location: Balto.Md
Posts: 382
|
Re: 1957 ford
Thread size is 5/16 coarse.
The bolt used is slightly shorter than 1" (but a 1" should be fine) with a 1/2 head , 5/16 coarse thread with a flat star washer. Oldmics |
Sponsored Links (Register now to hide all advertisements) |
|
08-19-2018, 03:35 AM | #3 |
Junior Member
Join Date: Feb 2016
Location: florida
Posts: 7
|
Re: 1957 ford
drag link end has a fine thread 28? tony
|
08-19-2018, 08:21 AM | #4 |
Senior Member
Join Date: Aug 2012
Location: IN A 'GALAXIE' FAR FAR AWAY
Posts: 6,485
|
Re: 1957 ford
You are probably going to have to measure the size if you have a drag link. There is no size info in cataloging.
__________________
***** We should have a contest. The player has to start at the very last post of a thread & then try to guess what the OP's original question was about ... |
08-19-2018, 09:05 AM | #5 |
BANNED
Join Date: Jul 2010
Location: Balto.Md
Posts: 382
|
Re: 1957 ford
Lets be sure that I am understanding what you are asking.
The picture below shows the control valve assemble. The bolt on the left side (loosened) that holds the control valve onto the drag link is the 1" 5/16 coarse bolt. The other side (right side) is a 1/4 X 1 1/2 long coarse slotted head screw. Are these the bolts you ask about ? Or are you looking for the larger fine thread bolts that hold the idler arm bracket to the frame ? Oldmics Last edited by Oldmics; 08-19-2018 at 09:19 AM. |
08-19-2018, 10:22 AM | #6 |
Senior Member
Join Date: Aug 2012
Location: IN A 'GALAXIE' FAR FAR AWAY
Posts: 6,485
|
Re: 1957 ford
Sponsored Links (Register now to hide all advertisements)
__________________
***** We should have a contest. The player has to start at the very last post of a thread & then try to guess what the OP's original question was about ... |
08-19-2018, 01:01 PM | #7 |
Junior Member
Join Date: Feb 2016
Location: florida
Posts: 7
|
Re: 1957 ford
yes the fine threads on the drag link end 1-24 ?or 1-28? will mic and get a thread gage tomorrow
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|