|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-10-2012, 05:44 PM | #21 |
Senior Member
|
Re: Opinions on using a Shortened Pitman Arm
|
12-10-2012, 05:51 PM | #22 | |
Senior Member
Join Date: May 2010
Location: Wa.
Posts: 5,409
|
Re: Opinions on using a Shortened Pitman Arm
Quote:
Any advice on welded steering or seat belt installation and subsequent failure could leave the advisor open to a lawsuit. Welded steering is illegal with many insurance companies. They won't say anything till they are investigating a claim. |
|
Sponsored Links (Register now to hide all advertisements) |
|
12-10-2012, 06:37 PM | #23 |
Senior Member
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
|
Re: Opinions on using a Shortened Pitman Arm
Terry,NJ For $35 why take a chance??
Paul in CT |
12-10-2012, 06:53 PM | #24 |
Senior Member
Join Date: May 2010
Location: Victoria, Australia
Posts: 1,177
|
Re: Opinions on using a Shortened Pitman Arm
|
12-10-2012, 07:17 PM | #25 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Opinions on using a Shortened Pitman Arm
Another advantage of the shorter pitman arm is that it takes some pressure off the gas tank bracket while turning the steering wheel.
|
12-11-2012, 11:49 AM | #26 |
Senior Member
Join Date: May 2010
Location: Didsbury Alberta
Posts: 838
|
Re: Opinions on using a Shortened Pitman Arm
Sponsored Links (Register now to hide all advertisements)
|
12-11-2012, 10:11 PM | #27 |
Senior Member
Join Date: Nov 2012
Location: Mays Landing, NJ
Posts: 113
|
Re: Opinions on using a Shortened Pitman Arm
So, this hard steering issue, on my recently acquired 29 Fordor, finally reached it's limit and I pulled the steering box out of the car tonight. I had previously removed the drag link from the pitman, trying to isolate where the stiffness was originating. It took a firm pull just to make the wheel turn with nothing attached. Driving the car was a 2-handed affair and very challenging.
What I found was that even though the box had been filled with grease, not 600, for years, every thing in there was fairly free and limber, except for the septor bushing, which was a bit on the dry side. I had been picking out the grease and shooting diesel fuel into the oil hole for the past week in an attempt to cut the grease down to a thinner mixture. The absolute MAJOR culprit was the WICK within the bushing at the top of the steering column. It was dry, hard and gummy and tight as all hell on the steering shaft. It took a brass drift and a deadblow hammer to get the shaft out of it! The shaft is actually blue from friction contact in that area. At this point, I'm not going to buy the shortened pitman arm. I'm going to put it all back together with new gaskets and bushings and take her for a spin. Thanks for everyone's input. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|