|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-06-2015, 08:16 PM | #1 |
Member
|
Tillotson carburetor ?
I know of the tillotson X but there a tillotson carb that looks simular to the zenith carb any idea were I can get gasket sets or info on them plus any idea if these are better then a zenith or the X carb
Plus will the zenith gasket sets interchange |
09-06-2015, 09:10 PM | #2 |
Senior Member
Join Date: May 2010
Location: Quincy, CA.
Posts: 1,708
|
Re: Tillotson carburetor ?
Buss,
The carb you are talking about is a F1B, the only thing, I believe, that is available is the gasket set; Smith and Jones Antique Auto Parts, 1-800-422-1928. The carb runs good if you clean all the passages; as a example, there is a seal on the mounting bolt that holds the two halves together, the reason is, the gas is around this bolt and there are two small passage-ways for gas in the lower housing above the bolt head. The F1B is also made of a ferious metal and sometimes you have to install heli-coils when the mounting bolts to intake manifold strip out. If you plan on rebuilding be sure you have all the jets, if not, look for a spare for parts. I can send you a article that shows all the passage-ways. Frankly I think you would be better with a original Zenith or Holley as all parts are available, they re cast iron and most are very re-buildable. Send me a PM if you want the F1B article. Ron |
Sponsored Links (Register now to hide all advertisements) |
|
09-06-2015, 09:35 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 106
|
Re: Tillotson carburetor ?
I believe you mean non ferious, basis for some Tillotson issues.
A's Always Dave |
09-07-2015, 12:13 PM | #4 |
Senior Member
Join Date: May 2010
Location: Cape Cod MA
Posts: 2,840
|
Re: Tillotson carburetor ?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|