|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-22-2020, 11:37 AM | #1 |
Senior Member
Join Date: May 2010
Location: Liberty, MO
Posts: 201
|
Tillison and Marvil carb
Does any one have float setting for tillison and marvel carbs thanks Richard
|
01-22-2020, 02:07 PM | #2 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,104
|
Re: Tillison and Marvil carb
__________________
www.whidbeymodelaclub.com |
Sponsored Links (Register now to hide all advertisements) |
|
01-22-2020, 02:08 PM | #3 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,104
|
Re: Tillison and Marvil carb
__________________
www.whidbeymodelaclub.com |
01-22-2020, 02:10 PM | #4 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,104
|
Re: Tillison and Marvil carb
Depends on type!
__________________
www.whidbeymodelaclub.com |
01-22-2020, 04:47 PM | #5 |
Senior Member
Join Date: May 2010
Location: Concord CA
Posts: 637
|
Re: Tillison and Marvil carb
For the Tilly, use 1". with upper half turned up side down, measure from gasket surface to top of float.
for Marvel, 15/16" with upper half turn up side down, measure from gasket surface to float seam, and the seam should be level to the gasket surface. Hope this helps. |
01-23-2020, 12:45 PM | #6 |
Senior Member
Join Date: May 2010
Location: Liberty, MO
Posts: 201
|
Re: Tillison and Marvil carb
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|