The Ford Barn

roadstar · 04-16-2012, 04:34 PM

Looking for a set of usable support rods for my 1937 ford pickup.

They should measure 26 inches in length.

All the repo ones I have found are universal mesureing 32 inches and there is no thread at 26 inches where I would have to cut it. Plus they are stainless steel and slightly thicker in diameter.

Will take used or new or a lead to someone selling the correct parts new.

Thanks.

f1builder · 04-16-2012, 05:49 PM

i have a set out of a 37 but i think they were 29". will double check later.

roadstar · 04-16-2012, 05:59 PM

Thanks

f1builder · 04-16-2012, 07:19 PM

Sponsored Links (Register now to hide all advertisements)

yup, 29" end to end. they are threaded on both ends an inch and a quarter or so. they are 26" between the nub that fits on the firewall (i think) and the bottom of the thread on the other end.

04-16-2012, 04:34 PM	#1
roadstar Member Join Date: May 2010 Location: Detroit Posts: 88	wanted 1937 pickup radiator support rods City: Detroit State: Mi Looking for a set of usable support rods for my 1937 ford pickup. They should measure 26 inches in length. All the repo ones I have found are universal mesureing 32 inches and there is no thread at 26 inches where I would have to cut it. Plus they are stainless steel and slightly thicker in diameter. Will take used or new or a lead to someone selling the correct parts new. Thanks.

04-16-2012, 05:49 PM	#2
f1builder Senior Member Join Date: Jan 2011 Posts: 554	Re: wanted 1937 pickup radiator support rods i have a set out of a 37 but i think they were 29". will double check later.

04-16-2012, 05:59 PM	#3
roadstar Member Join Date: May 2010 Location: Detroit Posts: 88	Re: wanted 1937 pickup radiator support rods Thanks

04-16-2012, 07:19 PM	#4
f1builder Senior Member Join Date: Jan 2011 Posts: 554	Re: wanted 1937 pickup radiator support rods Sponsored Links (Register now to hide all advertisements) yup, 29" end to end. they are threaded on both ends an inch and a quarter or so. they are 26" between the nub that fits on the firewall (i think) and the bottom of the thread on the other end.