06-12-2018, 06:59 PM | #1 |
Member
Join Date: Apr 2017
Location: Smithfield, Virginia
Posts: 76
|
i give up
I'm tired of searching for the name of the trim piece of body sheet metal that is located at the bottom of the body on at the rear end of a '30 fodor. runs across between the two fenders. must have a name.
and.........any ideas for finding one for a briggs body. |
06-12-2018, 07:10 PM | #2 |
Senior Member
Join Date: May 2010
Posts: 1,987
|
Re: i give up
Try valance
|
Sponsored Links (Register now to hide all advertisements) |
|
06-12-2018, 07:23 PM | #3 |
Senior Member
Join Date: Dec 2014
Location: Shawnee, Ok
Posts: 3,471
|
Re: i give up
And we have a winner...tell him what he's won Johnny....well Bob......
__________________
Keith Shawnee OK '31 SW 160-B |
06-12-2018, 07:52 PM | #4 |
Senior Member
Join Date: May 2010
Location: GA 30809
Posts: 629
|
Re: i give up
The "Model A Restoration Guidelines & Judging Standards" and the "MAFCA Paint & Finish Guide" refers to it as the "Rear Apron".
As to finding one, place an ad in the Swap Meet = Wanted section. |
06-12-2018, 09:00 PM | #5 |
Senior Member
Join Date: May 2010
Location: San Antonio, TX
Posts: 821
|
Re: i give up
the Briggs and Murray are different design so specify what you want.
__________________
Brian SATX |
06-12-2018, 10:54 PM | #6 |
Senior Member
Join Date: May 2010
Posts: 332
|
Re: i give up
Sponsored Links (Register now to hide all advertisements)
|
06-13-2018, 12:37 PM | #7 |
Member
Join Date: Apr 2017
Location: Smithfield, Virginia
Posts: 76
|
Re: i give up
tanx....all.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|