|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-20-2022, 06:43 PM | #1 |
Senior Member
Join Date: Dec 2011
Location: Ann Arbor / Canton Michigan
Posts: 318
|
Require 6v keyed power identification
Hello I am attempting to hook up a electric tachometer to my 40 Ford, the instructions require hooking up the power wire to a keyed power source on the ignition switch.
From the picture included here, I’d really appreciate it if someone can please verify the proper pole (1, 2 or 3) that I should used to power tachometer via a keyed source. Many thanks John |
06-20-2022, 10:14 PM | #2 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,115
|
Re: Require 6v keyed power identification
Quote:
John ....Does this help you any? You can easily see that the "BATTERY" is power IN. Either of the other two would be "Switched" power. Be careful NOT to get those nuts TOO tight. Hope this helps! Coop |
|
Sponsored Links (Register now to hide all advertisements) |
|
06-20-2022, 11:21 PM | #3 |
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,578
|
Re: Require 6v keyed power identification
Nice photo coop, that pretty much says it all
|
06-21-2022, 12:18 AM | #4 |
Senior Member
Join Date: Jan 2019
Location: Chicago
Posts: 732
|
Re: Require 6v keyed power identification
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|