01-02-2013, 02:37 PM | #1 |
Senior Member
Join Date: Feb 2011
Posts: 2,113
|
MARK USA Gears
The MARK USA Gears I just recieved have .005 clearance on my 1.25 main shaft. This is about .035+ more than my original gears.
This seems excessive, has anyone had any experience with these gears?
__________________
Tim Downtown, Ca |
01-02-2013, 03:00 PM | #2 |
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 5,963
|
Re: MARK USA Gears
Seems a bit loose. The bulletins reference the spline width and dia. Page 303. It says the dia of main shaft was changed to 1.2485/ 1.249 and the gears 1.2495/ 1.2505 Ford suggested assembling by selective fit.
|
Sponsored Links (Register now to hide all advertisements) |
|
01-02-2013, 05:28 PM | #3 |
Senior Member
Join Date: May 2010
Location: Portland, Oregon
Posts: 5,906
|
Re: MARK USA Gears
Sponsored Links (Register now to hide all advertisements)
__________________
Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|