|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-17-2023, 02:57 PM | #1 |
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,106
|
Rear Axle Rebuild
On page 47 of Tom Endy's 2014 paper there is reference to adjusting the backlash between the pinion and the ring gear. It is stated that the backlash may be between 0.010 and 0.020. Is this measured on the circumference of the drive shaft? Therefore, the amount of back and forth rotation of the drive shaft?
Thank you for your comments, Ed |
08-17-2023, 04:51 PM | #2 |
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: Rear Axle Rebuild
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|