|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-20-2010, 04:26 AM | #1 |
Senior Member
Join Date: May 2010
Location: Florence Ma.
Posts: 2,404
|
Here is a OLD GUY question ?????
Do any one know of any one in newEngland that knows how & can re/arch a set of rear car springs off the 53 Mainline ???????
|
05-20-2010, 06:21 AM | #2 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: Here is a OLD GUY question ?????
Hi Bill, You should look up a truck shop in your area, most of then should be able to do the job.
__________________
Imagination is more important than knowledge. |
Sponsored Links (Register now to hide all advertisements) |
|
05-20-2010, 07:22 AM | #3 |
Senior Member
Join Date: May 2010
Location: Florida and Penna.
Posts: 4,471
|
Re: Here is a OLD GUY question ?????
I have done a dozen of them in my press. Make an arch pattern on cardboard and keep making little bends over a long area one leaf at a time to match the patten. You can even arch the drivers side slightly more so it sits even on the early springs. G.M.
__________________
www.fordcollector.com |
05-20-2010, 07:31 AM | #4 |
Senior Member
Join Date: May 2010
Location: ManchVegas, New Hampshah
Posts: 1,589
|
Re: Here is a OLD GUY question ?????
Sponsored Links (Register now to hide all advertisements)
Donovan Spring Co., Inc. 6 Enterprise Drive Londonderry, NH 03053 Phone: (603) 627-9800 Toll Free: 1-800-458-3867 Fax: (603) 668-7135 Rod Hudoba: Manager Troy Robichard: Front End Department Frank Mangan: Service E-MAIL: [email protected]
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|