The Ford Barn

ldj1002 · 08-24-2011, 06:30 PM

I don't know which mount I have. Photo in Snyders doesn't look like mine. Yoke looks about same but my springs for each side are all one connected to each other and coils look larger. When engine is down the crank has to angle up to fit in ratchet. It does work. I thought crank should be level. When I removed engine all rubber fell out so don't know where it went for sure. If I didn't put one on top of cross member engine would go down enough for crank to engage ratchet level. It looks like a about 3/16' rubber goes on top of cross member then about 1" thick one goes underneath. How should they go?

08-24-2011, 06:30 PM	#1
ldj1002 Senior Member Join Date: Mar 2011 Posts: 181	Front motor mount question I don't know which mount I have. Photo in Snyders doesn't look like mine. Yoke looks about same but my springs for each side are all one connected to each other and coils look larger. When engine is down the crank has to angle up to fit in ratchet. It does work. I thought crank should be level. When I removed engine all rubber fell out so don't know where it went for sure. If I didn't put one on top of cross member engine would go down enough for crank to engage ratchet level. It looks like a about 3/16' rubber goes on top of cross member then about 1" thick one goes underneath. How should they go?