The Ford Barn

Mart · 07-04-2019, 10:21 AM

I know some Barners like machining so I hope you don't mind me posting this.

I just posted up a video in a new format for me. This is just short snips from hours of videos cut together in quick succession to show how I made a riser block for my milling machine from a very large but not ideally shaped piece of steel. The action shots were distilled down to less than 6 minutes from hours of video.

I hope you might like it, and any feedback is welcome, especially on whether the new format works for you. I'll also add my general channel address so you can check out all my offerings.

Mart.

Martsrods channel: https://www.youtube.com/channel/UCzc...Vro40j-vjjZShg

Riser Block video: https://youtu.be/CJQFRPjD71M

07-04-2019, 10:21 AM	#1
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,765	For Barners that like machining: Riser Block VIDEO. I know some Barners like machining so I hope you don't mind me posting this. I just posted up a video in a new format for me. This is just short snips from hours of videos cut together in quick succession to show how I made a riser block for my milling machine from a very large but not ideally shaped piece of steel. The action shots were distilled down to less than 6 minutes from hours of video. I hope you might like it, and any feedback is welcome, especially on whether the new format works for you. I'll also add my general channel address so you can check out all my offerings. Mart. Martsrods channel: https://www.youtube.com/channel/UCzc...Vro40j-vjjZShg Riser Block video: https://youtu.be/CJQFRPjD71M