Nut holding tool?
I had to remove my radio face plate to repaint to match the dash paiunt color better.
I am having trouble getting the last two face plate screws in. It is almost impossible to hold the nut on and even aligning it with the screw. This is a narrow space at the lower edge of the dash on my 1933
It is the type of job where a miniature glowing octopus is needed to handle the situation. Note: I left these two bottom screws off the first time I put the faceplate on to install my radio.
Last edited by FrankWest; 10-31-2015 at 10:34 AM.
|