|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-14-2019, 01:32 PM | #1 |
Junior Member
Join Date: Jan 2018
Location: 10 miles far from lake constance
Posts: 23
|
O-ring groove in flywheel housing
I tried to align the flywheel housing with the crank. Without
papergasket it`s easy to proceed the job, set from BILL BARLOW. Shimming here, shimming there, after 30 min. the job is done. Instead of using now the thick paper gasket I apply a string of silicone sealant the whole length of the sealing surface, place correct O - ring in the groove milled in the flywheel housing opposite the rear cam bearing, six screws are properly tightened to the correct torque. So the rear cam bearing is impossible to start leaking. Received the housing today and yes ---- I am happy Someone already knows this improvement ??????? |
|
|
Sponsored Links (Register now to hide all advertisements) |
|