The Ford Barn

LD-Ordie · 10-20-2019, 01:22 PM

So my parts were ordered with Murmmet Machining around 10:00 and parts were received next day by 4:00. Super fast getting them shipped out!! Thanks John! Saturday was spent at Gene Winfield's open house, so this morning was tear down day. So, I'm amazed to find what I did after carefully removing the intake.......I can't believe it ran as well as it did!! So I really have no way of knowing if the intake had been removed and or installed by the previous owner, or if this was done by the original builder. I would like to believe it wasn't, but who knows. Sure hope it did not do any damage by running so lean.

10-20-2019, 01:22 PM	#19
LD-Ordie Member Join Date: Jun 2018 Location: Ridgecrest, CA Posts: 74	Re: 292 vacuum leak So my parts were ordered with Murmmet Machining around 10:00 and parts were received next day by 4:00. Super fast getting them shipped out!! Thanks John! Saturday was spent at Gene Winfield's open house, so this morning was tear down day. So, I'm amazed to find what I did after carefully removing the intake.......I can't believe it ran as well as it did!! So I really have no way of knowing if the intake had been removed and or installed by the previous owner, or if this was done by the original builder. I would like to believe it wasn't, but who knows. Sure hope it did not do any damage by running so lean.