Need contact/website info. for Tony Baron

[Tim Ayers]

I've tried searching and didn't find much.
Does anyone have Tony Baron's current contact information and webiste?
I would like to know if he is still selling his 4X2 hi-rise intake.
Thanks.

[rotorwrench]

I'm not sure if he still has a web-site. This link has an e-mail address and his phone numbers are on the HAMB.
http://www.baronspeedequipment.com/

Kerby

[19Fordy]

Will this help? It came from this article.
http://www.hotrod.com/techarticles/e...ine/index.html
Baron Racing Equipment
Woodland Hills, CA
818/702-0043
www.baronracingequipment.com
Flathead engine builder, Baron heads, intake manifolds, main-bearing caps and supports, EFI intake manifolds, fuel-filter distribution blocks, air cleaner, Thickstun and Tattersfield speed equipment, comprehensive parts Flatlander Racing
Plaistow, NH
603/378-0090
www.flatlanderracing.com
Flathead stroker kits, rebuild kits, cams, bearings, pistons, rods, comprehensive engine parts

[uncle max]

Tony's direct email is: [email protected]
Tell him Hi...

[Funnycarguy]

Is this vendor still in business?

[HotRodmicky]

Sponsored Links (Register now to hide all advertisements)

Yes , but i tried to buy dual plug heads from him and it never worked out ....

[obster1a]

Tony Barron 818-702-0043

[obster1a]

Saw Tony just last week, he was at the polisher getting New Heads finished!

[Bored&Stroked]

Whups - didn't see the date of your original post . . . my bad . . .
Dale

=============

Hey Tim: Are you talking about the manifold that I have that is a sort of "cross-ram" port design - with a big plenum? If you're looking for this stuff, then contact Tom Roberts - here is a brochure with his stuff in it.

PriceGuide.pdf

IMG_6394.jpg

IMG_6395.JPG

IMG_6396.JPG

I've had this manifold since Tom was creating the patterns and needed a few 'partners' to go in with him. Tony was one of them (I was another). Tony/Tom have been friends for years - and have done quite a bit together. Anyway, thought this might help.

[Tim Ayers]

Originally Posted by Bored&Stroked

Whups - didn't see the date of your original post . . . my bad . . .
Dale

=============

Hey Tim: Are you talking about the manifold that I have that is a sort of "cross-ram" port design - with a big plenum? If you're looking for this stuff, then contact Tom Roberts - here is a brochure with his stuff in it.

Attachment 366291

Attachment 366292

Attachment 366293

Attachment 366294

I've had this manifold since Tom was creating the patterns and needed a few 'partners' to go in with him. Tony was one of them (I was another). Tony/Tom have been friends for years - and have done quite a bit together. Anyway, thought this might help.

Yo Dale:

Thanks for the post. I'm actually looking for the the Tattersfield/now Baron hi-rise 4X2. Way back, I was talking to Tony about getting heads and he mentioned the manifold you have and it was in the works. Sounds like a great idea with the interchangeable tops.

Have you have a chance to run it?

Back when I spoke to Tony, he was teaching HS. I'd assume he's retired by know since that was maybe 15-20 years ago.

Heard some vids of your ride. Motor sounds outrageous. Did you ever get those big 97's on it?