|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-09-2020, 04:15 PM | #1 |
Senior Member
Join Date: May 2010
Location: Santa Cruz
Posts: 391
|
'35 Ignition Lock, removing plunger pin?
I'm trying to pull the pin out of the Steering Wheel Lock Plunger -- some of the reading I've done calls it a "nail" -- but having no luck. Most "how-to" articles just say "remove pin..." (It's #10 on the diagram below).
Any secrets to yanking this guy out? A second question: With this pin in place, the "plunger" will not currently retract far enough to slide the entire column drop off the column tube. Is this normal? Thanks.
__________________
Seabright Hot Rods |
|
|
Sponsored Links (Register now to hide all advertisements) |
|